EN
8
Use for Intended Purpose
1. Use for Intended Purpose
The wenglor weQube is an optoelectronic sensor which is used for contactless inspection of specific objects.
The sensor unites a camera unit, illumination, optics with auto-focus and an analysis module in a single hous-
ing. The sensors work with a CMOS color or monochrome image sensor.
Image processing functions including measurement, object counting, checking for the presence of objects,
pixel comparison, shape analysis and reference image comparison can be configured by means of a PC or
laptop via the integrated Ethernet port. 1D and 2D codes can be read as well.
These image processing functions can be executed in trigger mode operation, as well as during continuous
monitoring, and objects can be detected regardless of position thanks to tracking. Six convertible I/O switching
outputs are available, which can be used as either inputs or outputs. Beyond this, an external lamp can also be
connected to the weQube, and the integrated illumination can be partially or completely switched off.
2. Safety Precautions
• These instructions are an integral part of the product and must be kept on hand for the entire duration of its
service life.
• Read the operating instructions carefully before using the product.
• This sensor is not suitable for safety applications.
• Installation, initial start-up and maintenance of the product should only be carried out by qualified personnel.
• Protect the sensor against mechanical influences.
• Tampering with or modifying the product is impermissible.
• Protect the sensor against contamination during initial start-up.
• The mounting screws must have a thread engagement length of 5 to 7 mm.
3. Approvals and protection class
To Next Page
Loading...