April 2017
8-89
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Product Technical Overview
Launch Issue
Stapler Assembly Carriage Rail and Move Motor
The stapler assemblies are moved into position along the carriage rail by the booklet stapler
move motor.
The booklet stapler move motor drives two rack gears, one connected to each stapler assem-
bly.
The position of the stapler assemblies is controlled by the booklet stapler move home sensor
and booklet stapler move position sensor which monitor the position of the rack gears. Refer to
Figure 38.
Figure 37 Stapler move motor
Crease Assembly
The crease assembly pre-creases sheets of paper prior to collating, stapling and stacking of
booklets.
It is installed behind the compiler within the Finisher LX and is controlled by the finisher PWB.
Refer to Figure 38.
Figure 38 Crease assembly
Crease Assembly Folder and Gears
The crease assembly consists of a folder knife motor, gears, crease blade and paper chute.
The folder knife motor raises and lowers the crease blade through one cycle of the gears.
Refer to Figure 39.
Figure 39 Crease assembly folder and gears
Booklet Stapler Move Home Sensor
and Booklet Stapler
Move Position Stapler
Booklet Stapler
Move Motor
Crease assembly
Crease
blade
Folder
knife
motor
To Next Page
Loading...
Need help?
General
Weight and Dimensions
