YOKOGAWA DLM4000 Series - Chapter 13 Waveform Histogram Display; Displaying Waveform Histograms

13-1
IM DLM4038-02EN
Chapter 13 Waveform Histogram Display
13.1 Displaying Waveform Histograms
This section explains the following settings (which are used when displaying a histogram of the
frequency of data occurrence in a specified area).
• Histogram display
• Source waveform
• Source axis
• The range over which the frequency is counted
►“DisplayingtheFrequencyDistributionofaWaveform”
in the Features Guide
ANALYSIS Histogram Menu
Press ANALYSIS and then the Histogram soft key to display the following menu.
Set the range over which to count the frequency.
Turns the histogram display on and off
Select whether to set Histogram1 or Histogram2.
Set the source waveform (CH1 to CH8, Math1 to Math4).
Set the source axis (Vertical, Horizontal).
Set the source window
(Main, Zoom1, Zoom2).
Set the upper and
lower limits.
• Upper limit
• Lower limit
Set the right and
left limits.
• Left side
• Right side