YOKOGAWA DLM4000 Series - Angle Cursor Measurements (Degree)

8-5
IM DLM4038-02EN
8.5 Angle Cursor Measurements (Degree)
This section explains the following settings (which are used when measuring with angle cursors).
• Cursor measurement
• Cursor type
• Source waveform
• Measurement items
• References
• Cursor jumping
• Cursor position
► “Angle Cursors (Degree)” in the Features Guide
CURSOR Menu
Press CURSOR to display the following menu.
Set measurement items.
Select the measurement items that you want to use.
Turns cursor measurement on and off
Set the cursor type to Degree.
Set the source waveform (All, CH1 to CH8, LOGIC(L),
*
LOGIC(A
|
B),
*
Math1 to Math4).
Cursor jumping
► section 8.1
Set the cursor position.
► section 8.1
* You can select CH8 or LOGIC(L), depending on which channel
’
s corresponding key (CH8 or L) is illuminated.
Specify the channel that you want to measure in advance by pressing either the CH8 key or the L key.
LOGIC(A|B) is available on models with the /L16 option.
Set the reference.
Setting the Reference (Reference Setup)
Press the Reference Setup soft key to display the following menu.
• Ref Cursor1: zero point
• Ref Cursor2: end point
Set the unit.
Set the reference angle
(using the jog shuttle).
Set the reference angle.
Set the reference cursor
(using the jog shuttle).