1-18
IM DLM4038-02EN
1.5 Copying Channel Information (Analog Signals)
You can copy the setup information of an analog signal input channel to other analog signal input
channels.
► “Copying Channel Information (Copy CH)” in the Features Guide
Copying Channel Information (Copy CH)
Press CH UTIL to display the following menu.
Set the copy destination.
Execute the copy operation. Undo the copy operation.
Set the channel to copy
from (CH1 to CH8).
• Select or deselect collectively.
Select or deselect the analog
signal channels to copy to.
• Select or deselect individually.
The source channel is dimmed and cannot
be individually selected or deselected.
If all the channels are selected collectively,
a check mark also appears next to the copy
source channel, but copying will not be
executed.
To Next Page
Loading...
