YOKOGAWA DLM4000 Series User Manual

19-4
IM DLM4038-02EN
19.4 Setting the Measured Value Font Size and
Whether to Use the Default Settings of Legacy
Models
This section explains the following settings (which are used when setting the font sizes of cursor-
measurement values and automatically measured values and the DLM4000 default values).
• Measured value font size
• Whether to use the default values of legacy models
►“Preferences(Preference)”and
“Returning to the Default Settings (DEFAULT SETUP)”
in the Features Guide
UTILITY Preference Menu
Press UTILITY and then press the Preference soft key to display the following menu.
Set whether to use the default
values of legacy models.
Turns offset cancelling on and off
► section 1.1
Set the output logic.
► Section 4.2 of the Getting Started Guide, IM DLM4038-03EN
Turns delay cancelling on and off
► section 2.2
Set the font size of measured values
(Small: 16 pt, Large: 24 pt).
Default Values of Legacy Models (Legacy Mode)
OFF: The default values are the DLM4000 factory default values.
ON: The default values are compatible with the DL7400 series default values.

YOKOGAWA DLM4000 Series Specifications

General

Brand	YOKOGAWA
Model	DLM4000 Series
Category	Test Equipment
Language	English