YOKOGAWA DLM4000 Series - Table of Contents

ix
IM DLM4038-02EN
Place alert marks in front of section 1.1 and 16.1
Contents
List of Manuals ................................................................................................................................... i
Conventions Used in This Manual ................................................................................................... iii
Key and Jog Shuttle Operations ......................................................................................................iv
Entering Values and Strings ............................................................................................................ vii
Chapter 1 Vertical and Horizontal Control
1.1 Setting the Vertical Axis for Analog Signals ...................................................................... 1-1
1.2 Setting the Vertical Axis for 8-bit LOGIC(L) ...................................................................... 1-6
1.3 Setting the Vertical Axis for 16-bit LOGIC(A|B) (Option) .................................................1-11
1.4 All ON/All OFF ................................................................................................................ 1-17
1.5 Copying Channel Information (Analog Signals) ............................................................. 1-18
1.6 Configuring the Horizontal Axis (Time axis) .................................................................... 1-19
Chapter 2 Triggering
2.1 Setting the Trigger Mode and Trigger Hold-off Time......................................................... 2-1
2.2 Setting the Trigger Position and Trigger Delay ................................................................. 2-2
Edge Trigger
2.3 Triggering on an Edge Trigger .......................................................................................... 2-3
Enhanced Trigger
2.4 Triggering on the OR of Multiple Edge Triggers ............................................................... 2-5
2.5 Triggering on Edge Conditions ......................................................................................... 2-7
2.6 Triggering on State Conditions ......................................................................................... 2-9
2.7 Triggering on Pulse Width ...............................................................................................2-11
2.8 Triggering on State Width ............................................................................................... 2-14
2.9 Triggering on FlexRay Bus Signals (Option) .................................................................. 2-17
2.10 Triggering on CAN Bus Signals (Option) ........................................................................ 2-20
2.11 Triggering on CAN FD Bus Signals (Option) .................................................................. 2-24
2.12 Triggering on LIN Bus Signals (Option) .......................................................................... 2-30
2.13 Triggering on SENT Signals (Option) ............................................................................. 2-34
2.14 Triggering on PSI5 Airbag Signals (Option) .................................................................... 2-42
2.15 Triggering on UART Signals (Option) ............................................................................. 2-45
2.16 Triggering on I
2
C Bus Signals (Option) .......................................................................... 2-49
2.17 Triggering on SPI Bus Signals (Option) .......................................................................... 2-54
2.18 Triggering on User-Defined Serial Bus Signals .............................................................. 2-58
2.19 Triggering on a TV Trigger .............................................................................................. 2-61
B Trigger
2.20 Triggering on Combination Triggers (B TRIG) ................................................................ 2-63
Forced Trigger
2.21 Forcing the DLM4000 to Trigger (FORCE TRIG) ........................................................... 2-66
Action and GO/NO-GO
2.22 Setting the Action-On-Trigger Function .......................................................................... 2-67
2.23 Performing GO/NO-GO Determination ........................................................................... 2-68
Chapter 3 Waveform Acquisition
3.1 Setting Conditions for Waveform Acquisition .................................................................... 3-1
3.2 Starting and Stopping Waveform Acquisition ................................................................... 3-2