14-1
IM DLM4038-02EN
Chapter 14 Power Supply Analysis (Power Analysis & Power Measurement; Option)
14.1 Setting the Power Supply Analysis Type or
Power Measurement
This section explains how to set the power supply analysis type and power measurement.
► “Overview of the Power Supply Analysis Feature” in the Features Guide
ANALYSIS Menu
Press ANALYSIS to display the following menu.
Set the power supply analysis type.
Power supply analysis (Power Analysis)
Power measurement (Power Measurement) ► section 14.6
Do not analyze.
Turns power measurement on and off
Switches to the serial bus signal analysis and search menu
The menu that appears when SHIFT+SERCH(SERIAL BUS) is pressed will appear.
► chapter 12
Select which power measurement to set
(Power Measurement1 to Power Measurement4).
Analyze switching loss.
► section 14.2
Analyze the safe operating area.
► section 14.3
Perform harmonic analysis.
► section 14.4
Measure the Joule integral.
► section 14.5
Select whether to set Power Analysis 1 or
Power Analysis 2.
Note
Power supply analysis and power measurement cannot be executed simultaneously. If any of the power
measurement items, Power Measurement1 to Power Measurement4, is set to ON, the power supply analysis
is set to OFF. If power supply analysis is set to something other than OFF, all power measurements are set
to OFF.
To Next Page
Loading...
