11-7
IM DLM4038-02EN
Searching Waveforms
11.3 Searching for State Conditions
This section explains the following settings (which are used when searching for state conditions).
• Search type
• Search range
Search start and end points
• State condition
Clock source, pattern, logic combination, search requirements, the level used to detect signal
states, and hysteresis
► “Search Type (Type),”
“Search Range (Start/End Point),” and
“Search Conditions (Condition Setup)”
in the Features Guide
SEARCH State Menu
Press SEARCH, the Type soft key, and then the State soft key to display the following menu.
Set the search type to State.
Configure the state conditions.
• Set the start point.
Configure the search range.
When You Press the Start/End Point Soft Key
Configure the detected waveform display. ►
Executes a search ► section 11.1
• Set the end point (fixed at 5 div).
To Next Page
Loading...
