9-1
IM DLM4038-02EN
Chapter 9 Automated Measurement of Waveform Parameters
9.1 Automatically Measuring Waveform Parameters
This section explains the following settings (which are used when automatically measuring waveform
parameters).
• Automated measurement
• The source waveform and measurement items
• The measurement location indicator
• The reference level for time measurements
• The measurement source window and the measurement range
► “Automated Measurement of Waveform Parameters” in the Features Guide
MEASURE Menu
Press MEASURE to display the following menu.
Configure the time range.
Set the measurement source window.
Set the reference levels for time measurements.
Set the measurement location indicator.
Set the source waveform and measurement items.
Turns automated measurement on and off
Process statistics on automatically measured values.
► section 9.2
Measure enhanced parameters.
► section 9.3
To Next Page
Loading...
