11-1
IM DLM4038-02EN
Searching Waveforms
11.1 Searching for Edges
This section explains the following settings (which are used when searching for edges).
• Search type
• Search range
Search start and end points
• Search conditions
Source, slope, the level used to detect source states, and hysteresis
• Detected waveform display
Detected point marks, zoom window, and zoom position
• Search skipping
• Executing searches
► “Search Type (Type),”
“Search Range (Start/End Point),”
“Search Conditions (Condition Setup),”
“Displaying Detected Waveforms (Display Setup),” and
“Search Skip (Skip Mode)”
in the Features Guide
SEARCH Edge Menu
Press SEARCH, the Type soft key, and then the Edge soft key to display the following menu.
Set the search type to Edge.
Configure the detected waveform display.
Configure search skipping.
Configure the search conditions.
• Set the start point.
• Set the end point.
Executes a search
Configure the search range.
When You Press the Start/End Point Soft Key
Chapter 11 Searching Waveforms
To Next Page
Loading...
