17-12
IM DLM4038-02EN
17.7 Loading Other Types of Data
This section explains the following settings (which are used when loading waveform zones, polygonal
zones, snapshot waveforms, or serial bus waveform symbol data).
• Displaying file information
• Data type to load
• Loading data
► “Loading Data (Load)” in the Features Guide
FILE Others (Load) Menu
Press FILE and then the Others (Load) soft key to display the following menu.
Displays file information
Set the data type to load.
File list Operation menu
Select the file that you want to load.
Selecting Files
Selectthefiletoloadfromthefilelist.►section17.8
Setting the Data Type to Load (Data Type)
Wave-Zone: Load waveform zone files that have .zwf extensions that you created on the
DLM4000 into internal memory areas Zone1 to Zone4.
Polygon-Zone: Load polygonal zone files that have .msk extensions that you created with the Mask
Editor software into internal memory areas Zone1 to Zone4.
Snap: Load snapshot waveform files that have .snp extensions that you have saved.
Symbol: Load physical value/symbol definition files that have .sbl extensions that you have
edited using the Symbol Editor tool.
To Next Page
Loading...
Need help?
General
