Zebra ZXP 9 Series

106 ZXP Series 9 Card Printer Service Manual P1086708-001
Theory of Operation
Card Movement During Printing
Step 8. If the printer has a laminator:
a. The card is moved through the X-Y Card transport into the laminator.
b. As the card passes through the laminator, laminating lm is applied to the card,
the top side or both sides depending on the laminator.
c. The card (with the laminating lm) then passes between a pair of heated rollers,
which seal the laminating lm to the card.
d. The card is moved from the laminator to the card exit, where it falls into the
Output Hopper attached to the left side of the laminator.
Step 9. If the printer does not have a laminator; the card moves through the X-Y card
transport to the card exit, where it falls into the output hopper attached to the left side
of the printer.