Zebra ZXP 9 Series

226 ZXP Series 9 Card Printer Service Manual P1086708-001
Replacement Procedures for the Printer
Required Tools
Required Tools
This section lists the tools required for the replacement procedures described in this section.
Naturally, not all tools are required for a particular procedure; specic tools are called out in each
step as appropriate.
y Flat-blade screwdrivers, from 1/16 inch (1.5 mm) to 1/4 inch (6.5 mm)
y TORX T6, T8, T10, T15, and T20 drivers
y Fine-point, offset ne-point, and needle-nose pliers
y Small diagonal cutters (or other cutter for cutting cable ties)
y 5.5 mm hex driver (this can also be used for securing push nuts)
y 3–10 mm e-ring clip tool
y Small and medium spring hook tools
y Adjustable wrench
y Cotton gloves
y Multimeter
y Several 30 mil cards (not to be reused)
y Zebra ZXP9 Tool Kit (Part No. 105936-058); kit includes:
 TOOL, TORQUE ADJUSTMENT (Zebra Kit # 105936-046)
 TOOL, INTM PAYOUT (Zebra Kit # 105936-047)
 TOOL, INTM TAKEUP (Zebra Kit # 105936-048)
 TOOL, PCBA REMOVAL (Zebra Kit # 105936-056)
 TOOL, CABLE ROUTING (Zebra Kit # 105936-057)