P1086708-001 ZXP Series 9 Card Printer Service Manual 355
Replacement Procedures for the Laminator
Procedures: Square Corner Spindle
Square Corner Spindle
For replacement, use Kit Spindle Square Corner 105936G-528. Contact Zebra Customer Service
at +01 877-275-9327 for ordering information.
Step 1. With a TORX T10 driver, remove the screw (arrow below) holding the square corner
spindle in place.
Step 2. Slide the square corner spindle off the spindle shaft.
Step 3. Set the square corner spindle aside.
To Next Page
Loading...