284 ZXP Series 9 Card Printer Service Manual P1086708-001
Replacement Procedures for the Printer
Procedures: Printhead Cam Position Sensor
Printhead Cam Position Sensor
For replacement, use Kit C/A Gap Sensor 105936G-018. Contact Zebra Customer Service at
+01 877-275-9327 for ordering information.
Step 1. With a TORX T6 driver, remove the two screws (arrows below) holding the printhead
cam position sensor in place.
Step 2. Disconnect the plug P24D.
Step 3. Remove the printhead cam position sensor.
Step 4. Set the printhead cam position sensor aside.
To Next Page
Loading...