P1086708-001 ZXP Series 9 Card Printer Service Manual 273
Replacement Procedures for the Printer
Procedures: Media Auth Coupler PCBAs
Media Auth Coupler PCBAs
InTM Coupler PCBA
For replacement, use Kit PCBA Media Auth Coupler 105936G-028. Contact Zebra Customer
Service at +01 877-275-9327 for ordering information.
The InTM coupler PCBA is attached to the spindle cover, which was removed in “InTM Payout
Assembly” on page 265.
Step 1. With a small at-blade screwdriver, carefully remove the two nylon snap fasteners
(arrows below) holding the InTM coupler PCBA to the spindle cover.
Step 2. Remove the InTM coupler PCBA.
To Next Page
Loading...