Name: Zebra ZXP 9 Series
Brand: Zebra
Rating: 4 (1 reviews)

To Next Page

To Previous Page

438 ZXP Series 9 Card Printer Service Manual P1086708-001

Packing for Shipment

If the printer is to be shipped, it is important to use the original packing and shipping material to

prevent damage to the printer.

If the original material is lost, a replacement shipping kit can be ordered from Zebra. Go to the ZXP

Series 9 support page at www.zebra.com/zxp9-info for more details.

Printer

Note • The specics of the shipment and the printer condition may inuence which of the following

steps are followed; common sense should prevail.

Step 1. Ensure the printer power is set to the off ( ) position.

Step 2. Disconnect the power cable from the power source, then from the rear of the printer.

Step 3. Disconnect the USB cable from the host computer, then from the rear of the printer;

or disconnect the Ethernet cable from the network source, then from the rear of the

printer.

Step 4. Remove any cards from the input and output hoppers—place the hoppers into the

foam insert.

Step 5. Open the printer door.

Step 6. Remove the print ribbon and transfer lm (if you wish to save the print ribbon and lm

for future use, you may want to put them in a plastic bag for storage).

Step 7. Remove the card cleaning cartridge and card cleaning roller—place them in the foam

insert.

Step 8. Close the printer door.

Output Hopper

Input Hopper

Cleaning Cartridge

Cleaning Roller

Step 9. Place the printer in its protective bag.

Step 10. Place the lower foam insert with the accessories into the shipping carton.

Questions and Answers:

Need help?

Do you have a question about the Zebra ZXP 9 Series and is the answer not in the manual?

Zebra ZXP 9 Series Specifications

General