Zebra ZXP 9 Series

P1086708-001 ZXP Series 9 Card Printer Service Manual 405
Replacement Procedures for the Laminator
Procedures: Laminator Beam
Laminator Beam
For replacement, use Kit Beam ZXP Laminator 105936G-500. Contact Zebra Customer Service at
+01 877-275-9327 for ordering information.
Removal
Step 1. Power-down the printer with the laminator. Note that the power switch on the printer
also controls the laminator.
Step 2. Remove the media (cards, ribbon, transfer lm, and laminate).
Step 3. Remove the back panel from the laminator:
a. Remove the three screws (circled below) holding the laminator back cover in
place.
b. Set the three screws and laminator back panel aside.