Zebra ZXP 9 Series User Manual

182 ZXP Series 9 Card Printer Service Manual P1086708-001
ZXP Toolbox
Dashboard
Dashboard
The Dashboard menu provides information about the printer. This printer information cannot be
edited or changed by the user. However, this information may be useful for Zebra trained and
certied personnel in diagnosing or evaluating printer status.
Printer
The Printer sub-menu shows general information about the printer. These elds are for information
purposes and are not editable from this page.
Firmware
Firmware version – Shows the version of printer rmware installed.
Laminator version – Shows the version of laminator rmware installed (displayed if laminator
present).
MAB version – Shows the version of printer media authentication board rmware installed.
HCB version – Shows the version of heater control board rmware installed.
Laminator MAB version – Shows the version of laminator media authentication board rmware
installed (displayed if laminator present).

Zebra ZXP 9 Series Specifications

General

Resolution	300 dpi
Card Capacity Output	100 cards
Memory	64 MB
Interface	USB, Ethernet
Operating Humidity	20% to 80% non-condensing
Print Technology	Dye Sublimation
Print Speed YMCK	Up to 190 cards/hour
Card Capacity Input	100 cards
Card Sizes	CR-80 ISO 7810
Connectivity	USB, Ethernet
Operating System	Windows, Linux
Options	Magnetic stripe encoding
Power Requirements	100-240V AC, 50/60Hz
Operating Temperature	15°C to 35°C
Card Thickness	10-40 mil