Zebra ZXP 9 Series User Manual

346 ZXP Series 9 Card Printer Service Manual P1086708-001
Replacement Procedures for the Laminator
Required Tools
Required Tools
This section lists the tools required for the replacement procedures described in this section.
Naturally, not all tools are required for a particular procedure; specic tools are called out in each
step as appropriate.
y Flat-Blade Screwdrivers, from 1/16 inch (1.5 mm) to 1/4 inch (6.5 mm)
y Phillips #0, #1 Screwdriver
y TORX T10, T15 Driver
y Adjustable Wrench
y Fine-Point, Offset Fine-Point, and Needle-Nose Pliers
y Small Diagonal Cutters or other cutter for cutting cable ties
y 5.5 mm Hex Driver (this can also be used for securing push nuts)
y 3–10 mm E-Ring Clip Tool
y Small and Medium Spring Hook Tools
y Cotton Gloves

Zebra ZXP 9 Series Specifications

General

Resolution	300 dpi
Card Capacity Output	100 cards
Memory	64 MB
Interface	USB, Ethernet
Operating Humidity	20% to 80% non-condensing
Print Technology	Dye Sublimation
Print Speed YMCK	Up to 190 cards/hour
Card Capacity Input	100 cards
Card Sizes	CR-80 ISO 7810
Connectivity	USB, Ethernet
Operating System	Windows, Linux
Options	Magnetic stripe encoding
Power Requirements	100-240V AC, 50/60Hz
Operating Temperature	15°C to 35°C
Card Thickness	10-40 mil