Zebra ZXP 9 Series

P1086708-001 ZXP Series 9 Card Printer Service Manual 349
Replacement Procedures for the Laminator
Procedures: Laminator
Procedures
Laminator
This procedure species how to separate the Laminator from the Printer to facilitate the removal and
replacement of selected parts in the Printer.
Detach
Step 1. Power-down the printer with the laminator. Note that the power switch on the printer
also controls the laminator.
Step 2. Remove the media (cards, ribbon, transfer lm, and laminate).
Step 3. Remove the three screws (circled below) holding the laminator back cover in place.
Step 4. Set the three screws and laminator back panel aside.