Zebra ZXP 9 Series

306 ZXP Series 9 Card Printer Service Manual P1086708-001
Replacement Procedures for the Printer
Procedures: Ethernet or Wireless PCBA
Ethernet or Wireless PCBA
For replacement, use Kit PCBA Ethernet 105936G-055; Kit WIreless (US) 105936G-066; Kit
Wireless (EMEA) 105936G-067. Contact Zebra Customer Service at +01 877-275-9327 for ordering
information.
Step 1. Set the printer on its side with the PCBA visible (and accessible) from the rear of the
printer; circled below.
Step 2. With a TORX T6 driver, remove the four screws (arrows below) holding the PCBA in
place.