Zebra ZXP 9 Series User Manual

1 ZXP Series 9 Card Printer Service Manual P1086708-001
1
Introduction
Description
This manual contains installation, operation, maintenance, troubleshooting, and networking
information for the Zebra ZXP Series 9 Card Printer; and describes single- and double-sided
printers, and double-sided printers with either a single- or double-sided laminator; and is intended to
be used by an operator, as well as an experienced IT person.
The Zebra ZXP Series 9 Card Printer uses reverse transfer printing technology to create photo-
quality and over-the-edge images on plastic identication cards. Zebra’s reverse transfer printers
provide fast throughput and a range of encoding options for a variety of markets and applications.
The single-sided laminator applies a laminating lm on the top surface of the printed card for added
security; the double-sided laminator applies laminating lm on both the top and bottom surfaces of
the card.
References in this document to “the laminator” apply to either a single- or double-sided laminator.

Zebra ZXP 9 Series Specifications

General

Resolution	300 dpi
Card Capacity Output	100 cards
Memory	64 MB
Interface	USB, Ethernet
Operating Humidity	20% to 80% non-condensing
Print Technology	Dye Sublimation
Print Speed YMCK	Up to 190 cards/hour
Card Capacity Input	100 cards
Card Sizes	CR-80 ISO 7810
Connectivity	USB, Ethernet
Operating System	Windows, Linux
Options	Magnetic stripe encoding
Power Requirements	100-240V AC, 50/60Hz
Operating Temperature	15°C to 35°C
Card Thickness	10-40 mil