P1086708-001 ZXP Series 9 Card Printer Service Manual 371
Replacement Procedures for the Laminator
Procedures: Top Laminator Control Motor
Top Laminator Control Motor
For replacement, use Kit Mtr Bi-Stp PM42L-048 RGT 8 105936G-512. Contact Zebra Customer
Service at +01 877-275-9327 for ordering information.
Step 1. With a TORX T10 driver, remove the two screws holding the top laminator control
motor in place. Note that the left screw connects a ground wire.
Step 2. If not already disconnected, disconnect the motor plug from J17.
Step 3. Cut the associated cable ties, and remove the top laminator control motor.
To Next Page
Loading...