Zebra ZXP 9 Series User Manual

P1086708-001 ZXP Series 9 Card Printer Service Manual 243
Replacement Procedures for the Printer
Procedures: Card Infeed Sensor
Card Infeed Sensor
For replacement, use Kit Sensor Card Infeed 105936G-034. Contact Zebra Customer Service at
+01 877-275-9327 for ordering information.
Step 1. With a TORX T10 driver, remove the four screws (circled below) holding the two
halves of the card feeder assembly together.
Step 2. Carefully separate the two halves.

Zebra ZXP 9 Series Specifications

General

Resolution	300 dpi
Card Capacity Output	100 cards
Memory	64 MB
Interface	USB, Ethernet
Operating Humidity	20% to 80% non-condensing
Print Technology	Dye Sublimation
Print Speed YMCK	Up to 190 cards/hour
Card Capacity Input	100 cards
Card Sizes	CR-80 ISO 7810
Connectivity	USB, Ethernet
Operating System	Windows, Linux
Options	Magnetic stripe encoding
Power Requirements	100-240V AC, 50/60Hz
Operating Temperature	15°C to 35°C
Card Thickness	10-40 mil