Zebra ZXP 9 Series

P1086708-001 ZXP Series 9 Card Printer Service Manual 159
Setting Custom Card Specications
Adjustments
Laminator Adjustments
While in most cases it is not necessary to adjust either the temperature, or the speed of the
lamination process, there may be times when it is. This may be due to the particular material of the
card, or because of adjustments made to the transfer process.
Temperature adjustments are in degrees Celsius, and are made by changing the value of either
the top or bottom laminate independently in one degree increments. However, changing values in
less than ve degree increments will take signicantly more time in establishing the correct card
specication.
Speed adjustment is in inches per second (IPS), and is made by changing the value of the
lamination speed to an accuracy of one one-hundredth of an inch.