P1086708-001 ZXP Series 9 Card Printer Service Manual 183
ZXP Toolbox
Dashboard
Other
Interface – Shows the current interface mode: USB, Ethernet, or Wireless Network.
Transfer type – Shows the current transfer setting: Single sided or Double sided.
Card type in use – Shows the type of cards currently being used in the printer (dened by the
Printing Preferences control panel).
Printer serial no – Shows the serial number of the printer.
Laminator serial no – Shows the serial number of the laminator.
OCP status – Shows the message currently being displayed on the operator control panel (OCP).
Network Conguration
IP address – Shows the IP address of the printer.
Gateway – Shows the gateway address of the printer.
Subnet mask – Shows the subnet mask of the printer.
MAC address – Shows the MAC address of the printer.
Options
Magnetic encoding – Shows the type of magnetic encoder installed in the printer: None or ISO.
Laminator type – Shows the type of laminator connected to the printer: Single sided or Double sided.
Smart Card Encoder type – Shows the type of smart card encoder installed in the printer: None,
Contact/Mifare, or Contact Station
Cards Printed/Laminated
Cards Printed – Shows how many cards have been printed.
Cards laminated – Shows how many cards have been laminated.
Print Performance
Print mode – Shows the current optimized printing mode: Standard or Fine (dened by the setting in
the Driver on the Printing Preferences > Card Setup page).
Error recovery mode – Shows the current error recovery mode: Full, Standard, or No Error Recovery
(dened by the setting in the Toolbox on the Printer Conguration > Firmware and Settings page).
To Next Page
Loading...
Need help?
General
