P1086708-001 ZXP Series 9 Card Printer Service Manual 145
Troubleshooting
Identifying Job Quality Issues
Flash
Flash is an artifact of the transfer process, that appears like little shards of transfer lm. The shards
may be clear or colored, depending on the image being printed. Flash may appear on the sides or
top of the card.
y If ash is seen on the top of the card, adjust the image placement downward. Use the Print
Position adjustment feature in the ZXP Toolbox, located in the Calibration tab. If this does not
minimize or resolve the issue, contact Zebra Technical Support.
y If ash is seen on the sides of the card, contact Zebra Technical Support.
Delamination
Delamination is the separation of the card layers and may be caused by using substandard cards.
If this occurs, contact Zebra Tech Support.
To Next Page
Loading...