P1086708-001 ZXP Series 9 Card Printer Service Manual 185
ZXP Toolbox
Dashboard
Film strip blocked – Shows the state of the lm strip sensor. The state changes depending on
whether the black mark is blocking the sensor or not.
Card feeder blocked – Shows the state of the card feeder sensor. The state changes depending on
whether cards are in the input hopper or not.
Card edge blocked – Shows the state of the card detect sensor in the center of the card transport.
The state changes depending on whether a card is blocking the sensor or not.
Printer lock sensor – Not used at this time.
Sensor Values
Voltage24 – Shows the voltage of the 24 volt power inside the printer.
Voltage AC – Shows the voltage of the AC power input to the printer.
Printhead temp – Shows the current temperature of the printhead.
Top transfer temp – Shows the current temperature of the top transfer roller.
Bottom transfer temp – Shows the current temperature of the bottom transfer roller.
To Next Page
Loading...