Zebra ZXP 9 Series User Manual

190 ZXP Series 9 Card Printer Service Manual P1086708-001
ZXP Toolbox
Dashboard
Noise oor – Shows the level of RF noise in the area surrounding the printer. Lower numbers
indicate less noise.
RSSI – Shows the relative signal strength of the access point to the printer. Higher numbers indicate
greater strength.
Rate – Shows the raw data rate, in megabits per second, of the connection from the printer to the
access point.
SSID – Shows the name of the wireless network.
Channel – Shows the wireless channel that the printer connection to the access point is using.
Encryption – Shows the encryption method used by the current security.
Link lost – Shows a counter of the number of times the link to the wireless network has been lost.
Wireless Radio Setting
This section shows statistics for the connection to the wireless network, that may be helpful in
troubleshooting connection issues.
Network Conguration
IP address – Shows the IP address of the printer on the wireless network.
Subnet mask – Shows the Subnet mask of the printer on the wireless network.
Gateway – Shows the Gateway of the printer on the wireless network.
MAC address – Shows the wireless MAC address of the printer.
Sent
This section shows statistics for the connection to the wireless network, that may be helpful in
troubleshooting connection issues.
Received
This section shows statistics for the connection to the wireless network, that may be helpful in
troubleshooting connection issues.

Zebra ZXP 9 Series Specifications

General

Resolution	300 dpi
Card Capacity Output	100 cards
Memory	64 MB
Interface	USB, Ethernet
Operating Humidity	20% to 80% non-condensing
Print Technology	Dye Sublimation
Print Speed YMCK	Up to 190 cards/hour
Card Capacity Input	100 cards
Card Sizes	CR-80 ISO 7810
Connectivity	USB, Ethernet
Operating System	Windows, Linux
Options	Magnetic stripe encoding
Power Requirements	100-240V AC, 50/60Hz
Operating Temperature	15°C to 35°C
Card Thickness	10-40 mil