Zebra ZXP 9 Series User Manual

196 ZXP Series 9 Card Printer Service Manual P1086708-001
ZXP Toolbox
Printer Conguration
BSSID – Shows the wireless MAC address of the access point.
Channel – Allows the user to select the channel for the wireless network. Pre-populated when a
network is selected.
Security – Allows the user to select the security for the wireless network. Pre-populated when a
network is selected.
Encryption – Allows the user to select the encryption for the wireless network. Pre-populated when a
network is selected.
Key – Allows the user to enter the hex key or passphrase for the wireless network. Can be left blank
only if the wireless network has open security.
Don’t save passphrase/passkey – Allows the user to determine whether the Toolbox saves the
passphrase for the selected wireless network, for later use.
Connect – Attempts to connect the printer to the selected wireless network.
Load Settings – Allows the user to load a previously saved XML of the wireless conguration.
Save Settings – Allows the user to save an XML of the wireless conguration.

Zebra ZXP 9 Series Specifications

General

Resolution	300 dpi
Card Capacity Output	100 cards
Memory	64 MB
Interface	USB, Ethernet
Operating Humidity	20% to 80% non-condensing
Print Technology	Dye Sublimation
Print Speed YMCK	Up to 190 cards/hour
Card Capacity Input	100 cards
Card Sizes	CR-80 ISO 7810
Connectivity	USB, Ethernet
Operating System	Windows, Linux
Options	Magnetic stripe encoding
Power Requirements	100-240V AC, 50/60Hz
Operating Temperature	15°C to 35°C
Card Thickness	10-40 mil