Zebra ZXP 9 Series User Manual

198 ZXP Series 9 Card Printer Service Manual P1086708-001
ZXP Toolbox
Encoding Settings
Magnetic Encoding Type
The selections in this section allow the user to specify that the data to be encoded on the card must
meet certain standards, which covers both the track settings and the type and number of characters
allowed on each track. ISO and AAMVA have xed track settings, Binary enables the Bit Density to
be changed for each track, and Custom enables most track settings to be changed for each track.
Track Settings
The selections in this section control various parameters of magnetic encoding. They can only be
edited if the Binary or Custom encoding types are selected.
Encode/Read Data
This section enables the user to test magnetic encoding. Cards can be both encoded and read. Note
that magnetic encoding type and track setting changes must be saved in order to apply to this utility.
Coercivity – Allows the user to set High coercivity or Low coercivity.
Hex encoding – Allows the user to specify whether the data is in hexadecimal format or standard
format.
Track 1 – Allows the user to specify whether to use Track 1 when performing the specied operation.
Characters must conform to the standard for the magnetic encoding type selected.
Track 2 – Allows the user to specify whether to use Track 2 when performing the specied operation.
Characters must conform to the standard for the magnetic encoding type selected.
Track 3 – Allows the user to specify whether to use Track 3 when performing the specied operation.
Characters must conform to the standard for the magnetic encoding type selected.
Read – Allows the user to read the card inserted in the input hopper. The card will be ejected after
the operation is completed.
Encode – Allows the user to encode the card inserted in the input hopper. The card will be ejected
after the operation is completed.
Restore Defaults – Allows the user to restore all settings on this page to their default setting.
Save Settings – Allows the user to save all changes to settings on this page.

Zebra ZXP 9 Series Specifications

General

Resolution	300 dpi
Card Capacity Output	100 cards
Memory	64 MB
Interface	USB, Ethernet
Operating Humidity	20% to 80% non-condensing
Print Technology	Dye Sublimation
Print Speed YMCK	Up to 190 cards/hour
Card Capacity Input	100 cards
Card Sizes	CR-80 ISO 7810
Connectivity	USB, Ethernet
Operating System	Windows, Linux
Options	Magnetic stripe encoding
Power Requirements	100-240V AC, 50/60Hz
Operating Temperature	15°C to 35°C
Card Thickness	10-40 mil