216 ZXP Series 9 Card Printer Service Manual P1086708-001
ZXP Toolbox
Advanced Settings
Leading Edge Margin is adjusted via two sliders, one for the top of the card and one for the bottom of
the card. The displayed value can be increased (+) or decreased (-) in increments of 0.07 , for both
adjustments. Note that this adjustment positions the leading edge of the laminate with respect to the
leading edge of the card.
Trailing Edge Margin (both) is adjusted via one slider for both the top of the card and the bottom of
the card. The displayed value can be increased (+) or decreased (-) in increments of 0.06, for both
adjustments. Note that adjusting the trailing edge margin increases or decreases the length of both
laminate patches.
Patch Placement Adjust (both) is adjusted via one slider for both the top of the card and the bottom
of the card. The displayed value can be increased (+) or decreased (-) in increments of 0.06, for both
adjustments. Note that this adjustment positions the laminate on both top and bottom of the card.
Click on the Send button to send the adjustment to the printer. You have to click on the Save
Settings button to save the settings to EEPROM.
Restore Factory Defaults – Resets the values to the factory default.
Media Calibration – Calibrates the laminate sensor to see the leading edge of the laminate. That
data is used to determine the patch length and placement on the card.
Read From Laminator – Reads all the saved laminator parameters from the EEPROM.
Save Settings – Applies the changed values so they can be used in the future.
To Next Page
Loading...
Need help?
General
