Zebra ZXP 9 Series

P1086708-001 ZXP Series 9 Card Printer Service Manual 219
ZXP Toolbox
Advanced Settings
y reset system defaults – Resets all parameters to the original system default values. For
factory use only.
y reset media auth cfg – Resets the media authentication code to factory default value. For
factory use only.
y reset laminator serial number – Sets Laminator Serial number to zero.
y reset cards laminated – Sets the Cards Laminated Counter to zero.
y lock printer – Not applicable for the ZXP9 Series printers, since the ZXP9 does not have an
electrical lock option.
y unlock printer – Not applicable for the ZXP9 Series printers, since the ZXP9 does not have
an electrical lock option.
y clear i2c error stats – For factory use only.
Save Request – Saves the XML le to the default Cong folder; give the le a name of your choice,
and email the le to Zebra Technical Support.
Load Response – When you receive the response, save the XML le and select it by clicking Load
Response.
Set New Value – Reserved for future use.