256 ZXP Series 9 Card Printer Service Manual P1086708-001
Replacement Procedures for the Printer
Procedures: Halogen Bulb
Step 3. Remove the halogen bulb (circled below).
Step 4. Remove the halogen bulb.
Caution • NEVER TOUCH A HALOGEN BULB WITH BARE FINGERS. Handle it with a
wrap or gloves.
Replacement
Replacement is performed by reversing the removal steps.
After installing the replacement halogen bulb(s), use a multimeter to verify that both bulbs are
making proper connection.
Step 5. With a multimeter, measure the resistance across the bottom bulb connector pins
(J2).
Step 6. Resistance should range between 8 ohms and 15 ohms.
Step 1. With a multimeter, measure the resistance across the top bulb connector pins (J3).
Step 2. Resistance should range between 8 ohms and 15 ohms.
Step 3. If the resistance is our of range, re-seat the halogen bulb(s), and repeat the
resistance measurement.
To Next Page
Loading...