Zebra ZXP 9 Series

332 ZXP Series 9 Card Printer Service Manual P1086708-001
Replacement Procedures for the Printer
Procedures: Mag Encoder
Step 7. If the test nishes successfully, the Tool will return a TEST PASS.
Step 8. If the test is not successful, the Tool will return an TEST FAIL. If this happens, run the
test again. If the test continues to fail, check the mag encoder and run the test again.
If the test continues to fail, replace the mag encoder.
Step 9. Select the Mag Write Test and click .
Step 10. Follow the on-screen instructions.
Step 11. If the test nishes successfully, the Tool will return a TEST PASS.
Step 12. If the test is not successful, the Tool will return an TEST FAIL. If this happens, run the
test again. If the test continues to fail, check the mag encoder and run the test again.
If the test continues to fail, replace the mag encoder.