P1086708-001 ZXP Series 9 Card Printer Service Manual 359
Replacement Procedures for the Laminator
Procedures: Halogen Bulbs
Replacement
Replacement is performed by reversing the removal steps.
After installing the replacement halogen bulb(s), use a multimeter to verify that both bulbs are
making proper connection.
Step 1. With a multimeter, measure the resistance across the top bulb connector pins.
Step 2. Resistance should range between 8 ohms and 15 ohms.
Step 3. With a multimeter, measure the resistance across the bottom bulb connector pins.
Step 4. Resistance should range between 8 ohms and 15 ohms.
Step 5. If the resistance is our of range, re-seat the halogen bulb(s), and repeat the
resistance measurement.
To Next Page
Loading...