Chapter 9 Wireless LAN Profiles
ZyWALL Series CLI Reference Guide
80
The following table describes the commands available for radio and monitor profile management. You
must use the
configure terminal command to enter the configuration mode before you can use
these commands.
wlan_htgi
Sets the HT guard interval. Select either long or short.
chain_mask
Sets the network traffic chain mask. The range is 1 ~ 7.
wlan_power
Sets the radio output power.
scan_method
Sets the radio’s scan method while in Monitor mode. Select manual or auto.
wlan_interface_index
Sets the radio interface index number. The range is 1 ~ 8.
ssid_profile
Sets the associated SSID profile name. This name must be an existing SSID profile.
You may use 1-31 alphanumeric characters, underscores (
_), or dashes (-), but the
first character cannot be a number. This value is case-sensitive.
Table 21 Command Summary: Radio Profile
COMMAND DESCRIPTION
show wlan-radio-profile {all |
radio_profile_name}
Displays the radio profile(s).
all: Displays all profiles.
radio_profile_name: Displays the specified profile.
wlan-radio-profile rename
radio_profile_name1
radio_profile_name2
Gives an existing radio profile (radio_profile_name1) a
new name (radio_profile_name2).
[no] wlan-radio-profile
radio_profile_name
Enters configuration mode for the specified radio profile. Use
the no parameter to remove the specified profile.
2g-basic-speed speed
2g-channel wireless_channel_2g
Sets the broadcast band for this profile in the 2.4 GHz
frequency range. The default is 6.
2g-multicast-speed
wlan_2g_support_speed
When you disable multicast to unicast, use this command to
set the data rate { 1.0 | 2.0 | … } in Mbps for 2.4 GHz
multicast traffic.
2g-wlan-rate-control rate_2g
Sets the minimum data rate that 2.4Ghz WiFi clients can
connect at, in Mbps. At the time of write, allowed values are:
1, 2,5. 5, 6, 9, 11, 12, 18, 24, 36, 48, 54.
Increasing the minimum data rate can reduce network
overhead and improve WiFi network performance in high
density environments. However, WiFi clients that do not
support the minimum data rate will not be able to connect to
the AP.
5g-basic-speed speed
5g-channel wireless_channel_5g
Sets the broadcast band for this profile in the 5 GHz
frequency range. The default is 36.
5g-multicast-speed
wlan_5g_basic_speed
When you disable multicast to unicast, use this command to
set the data rate { 6.0 | 9.0 | … } in Mbps for 5 GHz
multicast traffic.
Table 20 Input Values for General Radio and Monitor Profile Commands (continued)
LABEL DESCRIPTION
To Next Page
Loading...
