Chapter 9 Wireless LAN Profiles
ZyWALL Series CLI Reference Guide
81
5g-wlan-rate-control rate_5g
Sets the minimum data rate that 5Ghz WiFi clients can
connect at, in Mbps. At the time of write, allowed values are:
6,9, 12, 18, 24, 36, 48, 54.
Increasing the minimum data rate can reduce network
overhead and improve WiFi network performance in high
density environments. However, WiFi clients that do not
support the minimum data rate will not be able to connect to
the AP.
[no] activate
Makes this radio profile active or inactive.
[no] ampdu
Activates MPDU frame aggregation for this profile. Use the no
parameter to disable it.
Message Protocol Data Unit (MPDU) aggregation collects
Ethernet frames along with their 802.11n headers and wraps
them in a 802.11n MAC header. This method is useful for
increasing bandwidth throughput in environments that are
prone to high error rates.
By default this is enabled.
limit-ampdu < 100..65535>
Sets the maximum frame size to be aggregated using MPDU.
By default this is 50000.
subframe-ampdu <2..64>
Sets the maximum number of frames to be aggregated each
time.
By default this is 32.
[no] amsdu
Activates MPDU frame aggregation for this profile. Use the no
parameter to disable it.
Mac Service Data Unit (MSDU) aggregation collects Ethernet
frames without any of their 802.11n headers and wraps the
header-less payload in a single 802.11n MAC header. This
method is useful for increasing bandwidth throughput. It is
also more efficient than A-MPDU except in environments that
are prone to high error rates.
By default this is enabled.
limit-amsdu <2290..4096>
Sets the maximum frame size to be aggregated using MPDU.
The default is 4096.
Table 21 Command Summary: Radio Profile (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
