Chapter 9 Wireless LAN Profiles
ZyWALL Series CLI Reference Guide
86
[no] suppress-retry-rts
tx-mask chain_mask
Sets the outgoing chain mask rate.
[no] zero-wait-dfs
Enables or disables zero-wait DFS (Dynamic Frequency
Selection) on the AP.
Note: Zero-wait DFS is only supported on certain AP
models, such as the WAX650S.
DFS is a channel WiFi allocation scheme that allows APs to
use channels in the 5Ghz band normally reserved for radar.
Before using a DFS channel, an AP must ensure that no radar
present by performing a Channel Availability Check (CAC).
This check takes 1-10 minutes, depending on the country in
which the AP is located.
Zero-Wait DFS allows an AP to provide network services to
WiFi clients using a primary 5Ghz radio, while simultaneously
checking DFS channels for the presence of radar using a
secondary 5Ghz radio. If no radar is detected on a DFS
channel, the AP adds it to a list of cleared channels. The AP
can then switch the primary radio to any cleared DFS
channel without having to wait 1-10 minutes for a Channel
Availability Check.
Note: When zero-wait DFS is enabled, 5Ghz DFS Aware
(dcs dfs-aware) and Blacklist DFS Channels
(nol-channel-block) are automatically
disabled on the AP.
exit
Exits configuration mode for this profile.
storm-control ethernet ap
mac_address
Enables Ethernet storm control and then enters the Ethernet
storm control sub-command mode for the specified radio
profile.
Ethernet storm control prevents WiFi clients from receiving
excessive broadcast or multicast traffic sent from wired
clients in the same subnet.
[no] broadcast
Enables or disables broadcast storm control, which drops
broadcast packets from ingress traffic if the traffic rate
exceeds the configured maximum rate.
broadcast pps <1~10000>
Sets the maximum allowed rate for broadcast traffic, in
packets per second.
[no] multicast
Enables or disables multicast storm control, which drops
multicast packets from ingress traffic if the traffic rate
exceeds the configured maximum rate.
multicast pps <1~10000>
Sets the maximum allowed rate for multicast traffic, in
packets per second.
exit
Exits configuration mode for this profile.
no storm-control ethernet ap
mac_address
Disables Ethernet broadcast and multicast storm control, and
removes all Ethernet storm control settings for the specified
AP.
Table 21 Command Summary: Radio Profile (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
