Chapter 9 Wireless LAN Profiles
ZyWALL Series CLI Reference Guide
87
storm-control wireless ap
mac_address
Enables wireless storm control and then enters the wireless
storm control sub-command mode for the specified AP.
Wireless storm control prevents wired clients from receiving
excessive broadcast or multicast traffic sent from WiFi clients
in the same subnet.
Note: To enable wireless storm control, Remote AP
must be enabled on the AP and the AP must be
running firmware version 6.20 or later.
[no] broadcast
Enables or disables broadcast storm control, which drops
broadcast packets from ingress traffic if the traffic rate
exceeds the configured maximum rate.
broadcast pps <1~10000>
Sets the maximum allowed rate for broadcast traffic, in
packets per second.
[no] multicast
Enables or disables multicast storm control, which drops
multicast packets from ingress traffic if the traffic rate
exceeds the configured maximum rate.
multicast pps <1~10000>
Sets the maximum allowed rate for multicast traffic, in
packets per second.
exit
Exits configuration mode for this profile.
no storm-control wireless ap
mac_address
Disables wireless broadcast and multicast storm control, and
removes all wireless storm control settings for the specified
AP.
show storm-control ethernet ap
mac_address
Displays broadcast/multicast storm control settings on the
specified AP.
show wlan-monitor-profile {all |
monitor_profile_name}
Displays all monitor profiles or just the specified one.
wlan-monitor-profile rename
monitor_profile_name1
monitor_profile_name2
Gives an existing monitor profile (monitor_profile_name1)
a new name (monitor_profile_name2).
[no] wlan-monitor-profile
monitor_profile_name
Enters configuration mode for the specified monitor profile.
Use the no parameter to remove the specified profile.
[no] activate
Makes this profile active or inactive.
By default, this is enabled.
country-code country_code
Sets the country where the Zyxel Device is located/installed.
The available channels vary depending on the country you
selected. Be sure to select the correct/same country for both
radios on an AP and all connected APs, in order to prevent
roaming failure and interference to other systems.
country_code: 2-letter country-codes, such as TW, DE, or FR.
scan-method scan_method
Sets the channel scanning method for this profile.
[no] 2g-scan-channel
wireless_channel_2g
Sets the broadcast band for this profile in the 2.4 Ghz
frequency range. Use the no parameter to disable it.
[no] 5g-scan-channel
wireless_channel_5g
Sets the broadcast band for this profile in the 5 GHz
frequency range. Use the no parameter to disable it.
scan-dwell <100..1000>
Sets the duration in milliseconds that the device using this
profile scans each channel.
exit
Exits configuration mode for this profile.
Table 21 Command Summary: Radio Profile (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
