Chapter 9 Wireless LAN Profiles
ZyWALL Series CLI Reference Guide
90
[no] bandselect balance-ratio
<1..8>
Sets a ratio of the wireless clients using the 5 GHz band to the
wireless clients using the 2.4 GHz band. Use the no parameter to
turn off this feature.
bandselect check-sta-interval
<1..60000>
Sets how often (in seconds) the AP checks and deletes old
wireless client data.
bandselect drop-authentication
<1..16>
Sets how many authentication request from a client to a 2.4GHz
Wi-Fi network is ignored during the specified timeout period.
bandselect drop-probe-request
<1..32>
Sets how many probe request from a client to a 2.4GHz Wi-Fi
network is ignored during the specified timeout period.
bandselect min-sort-interval
<1..60000>
Sets the minimum interval (in seconds) at which the AP sorts the
wireless client data when the client queue is full.
bandselect mode {disable |
force | standard}
To improve network performance and avoid interference in the
2.4 GHz frequency band, you can enable this feature to use the
5 GHz band first. You should set 2.4GHz and 5 GHz radio profiles
to use the same SSID and security settings.
Note: The managed APs must be dual-band capable.
disable: to turn off this feature.
force: to have the wireless clients always connect to an SSID
using the 5 GHZ band. Connections to an SSID using the 2.4GHz
band are not allowed. It is recommended you select this option
when the AP and wireless clients can function in either
frequency band.
standard: to have the AP try to connect the wireless clients to
the same SSID using the 5 GHZ band. Connections to an SSID
using the 2.4GHz band are still allowed.
[no] bandselect stop-threshold
<10..20>
Sets the threshold number of the connected wireless clients at
which the AP disables the band select feature. Use the no
parameter to turn off this feature.
bandselect time-out-force
<1..255>
Sets the timeout period (in seconds) within which the AP
accepts probe or authentication requests to a 2.4GHz Wi-Fi
network when the band select mode is set to force.
bandselect time-out-period
<1..255>
Sets the timeout period (in seconds) within which the AP drops
the specified number of probe or authentication requests to a
2.4GHz Wi-Fi network.
bandselect time-out-standard
<1..255>
Sets the timeout period (in seconds) within which the AP
accepts probe or authentication requests to a 2.4GHz Wi-Fi
network when the band select mode is set to standard.
[no] block-intra
Enables intra-BSSID traffic blocking. Use the no parameter to
disable it in this profile.
By default this is disabled.
data-forward localbridge
Sets the data forwarding mode used by the SSID to localbridge
mode.
In this mode, all of the wireless station’s traffic is routed through
the associated AP’s gateway and tagged with the VLAN ID set
by command
vlan-id.
This is the default data forwarding mode.
Table 23 Command Summary: SSID Profile (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
