Chapter 9 Wireless LAN Profiles
ZyWALL Series CLI Reference Guide
91
data-forward tunnel interface
Sets the data forwarding mode used by the SSID to tunnel
mode.
In this mode, all of the wireless station’s traffic is routed through
the Zyxel Device via the specified interface.
Note: The interface must be a VLAN or internal Ethernet
interface. The interface cannot be a member of a
bridge.
downlink-rate-limit data_rate
Sets the maximum incoming transmission data rate (either in
mbps or kbps) on a per-station basis.
[no] hide
Prevents the SSID from being publicly broadcast. Use the no
parameter to re-enable public broadcast of the SSID in this
profile.
By default this is disabled.
[no] macfilter
macfilterprofile
Assigns the specified MAC filtering profile to this SSID profile. Use
the no parameter to remove it.
By default, no MAC filter is assigned.
qos wlan_qos
Sets the type of QoS used by this SSID.
security securityprofile
Assigns the specified security profile to this SSID profile.
ssid
Sets the SSID. This is the name visible on the network to wireless
clients. Enter up to 32 characters, spaces and underscores are
allowed.
The default SSID is ‘ZyXEL’.
[no] ssid-schedule
Enables the SSID schedule. Use the no parameter to disable the
SSID schedule.
{mon|tue|wed|thu|fri|sat|sun}
{disable | enable} <hh:mm>
<hh:mm>
Sets whether the SSID is enabled or disabled on each day of the
week. This also specifies the hour and minute (in 24-hour format)
to set the time period of each day during which the SSID is
enabled/enabled.
<hh:mm> <hh:mm>: If you set both start time and end time to
00:00, it indicates a whole day event.
Note: The end time must be larger than the start time.
uplink-rate-limit data_rate
Sets the maximum outgoing transmission data rate (either in
mbps or kbps) on a per-station basis.
vlan-id <1..4094>
Applies to each SSID profile that uses localbridge. If the VLAN
ID is equal to the AP’s native VLAN ID then traffic originating
from the SSID is not tagged.
The default VLAN ID is 1.
exit
Exits configuration mode for this profile.
Table 23 Command Summary: SSID Profile (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
