ABB REG670 - Settings

Table 809: MULTICMDSND Output signals
Name Type Description
ERROR BOOLEAN MultiSend error
18.13.5 Settings
Table 810: MULTICMDRCV Non group settings (basic)
Name Values (Range) Unit Step Default Description
tMaxCycleTime 0.050 - 200.000 s 0.001 11.000 Maximum cycle time between receptions
of input data
tMinCycleTime 0.000 - 200.000 s 0.001 0.000 Minimum cycle time between receptions
of input data
Mode Steady
Pulsed
- - Steady Mode for output signals
tPulseTime 0.000 - 60.000 s 0.001 0.200 Pulse length for multi command outputs
Table 811: MULTICMDSND Non group settings (basic)
Name Values (Range) Unit Step Default Description
tMaxCycleTime 0.000 - 200.000 s 0.001 5.000 Maximum time interval between
transmission of output data
tMinCycleTime 0.000 - 200.000 s 0.001 0.000 Minimum time interval between
transmission of output data
18.13.6 Operation principle
There are 10 instances of the MULTICMDSND function block. The first two are fast
(8 ms cycle time) while the others are slow (100 ms cycle time). Each instance has 16
binary inputs, to which 16 independent signals can be connected. Connected signals
are sent through MULTICMDSND to the receiving equivalent, MULTICMDRCV,
located on a different IED.
The MULTICMDRCV function block has 16 binary outputs, all controlled through
the command block of one or many MULTICMDSND function blocks. There are 60
instances of the MULTICMDRCV where the first 12 are fast (8 ms), and the others are
slow (100 ms). Additionally, the MULTICMDRCV has a supervision function, which
sets the output connector "VALID" to 0 (zero) if its block does not receive any data
within the time defined by tMaxCycleTime.
LON connections are established using LON network tool (LNT).
Section 18 1MRK502052-UEN B
Station communication
1076
Technical manual