Name Type Default Description
BI4 BOOLEAN 0 SMT Connect input
BI5 BOOLEAN 0 SMT Connect input
BI6 BOOLEAN 0 SMT Connect input
BI7 BOOLEAN 0 SMT Connect input
BI8 BOOLEAN 0 SMT Connect input
BI9 BOOLEAN 0 SMT Connect input
BI10 BOOLEAN 0 SMT Connect input
Table 855: SMBI Output signals
Name Type Description
BI1 BOOLEAN Binary input 1
BI2 BOOLEAN Binary input 2
BI3 BOOLEAN Binary input 3
BI4 BOOLEAN Binary input 4
BI5 BOOLEAN Binary input 5
BI6 BOOLEAN Binary input 6
BI7 BOOLEAN Binary input 7
BI8 BOOLEAN Binary input 8
BI9 BOOLEAN Binary input 9
BI10 BOOLEAN Binary input 10
20.12.4 Operation principle
The Signal matrix for binary inputs (SMBI) function , see figure 509, receives its
inputs from the real (hardware) binary inputs via the Signal Matrix Tool (SMT) or
ACT, and makes them available to the rest of the configuration via its outputs, BI1 to
BI10. The inputs and outputs, as well as the whole block, can be given a user defined
name. These names will be represented in SMT as information which signals shall be
connected between physical IO and SMBI function. The input/output user defined
name will also appear on the respective output/input signal.
20.13 Signal matrix for binary outputs SMBO
20.13.1 Functionality
The Signal matrix for binary outputs (SMBO) function is used within the Application
Configuration Tool (ACT) in direct relation with the Signal Matrix Tool (SMT), see
1MRK502052-UEN B Section 20
Basic IED functions
1125
Technical manual
To Next Page
Loading...
