ABB REG670 - Settings

Name Type Description
SFREQ REAL Slip frequency
SLIPZOHM REAL Slip impedance in ohms
SLIPZPER REAL Slip impedance in percent of ZBase
UCOS REAL UCosPhi voltage
UCOSPER REAL UCosPhi voltage in percent of UBase
7.5.5 Settings
Table 101: PSPPPAM Group settings (basic)
Name Values (Range) Unit Step Default Description
Operation Off
On
- - Off Operation On / Off
OperationZ1 Off
On
- - On Operation Zone1 On / Off
OperationZ2 Off
On
- - On Operation Zone2 On / Off
ImpedanceZA 0.00 - 1000.00 % 0.01 10.00 Forward impedance in % of Zbase
ImpedanceZB 0.00 - 1000.00 % 0.01 10.00 Reverse impedance in % of Zbase
ImpedanceZC 0.00 - 1000.00 % 0.01 10.00 Impedance of zone1 limit in % of Zbase
AnglePhi 72.00 - 90.00 Deg 0.01 85.00 Angle of the slip impedance line
StartAngle 0.0 - 180.0 Deg 0.1 110.0 Rotor angle for the start signal
TripAngle 0.0 - 180.0 Deg 0.1 90.0 Rotor angle for the trip1 and trip2 signals
N1Limit 1 - 20 - 1 1 Count limit for the trip1 signal
N2Limit 1 - 20 - 1 3 Count limit for the trip2 signal
Table 102: PSPPPAM Group settings (advanced)
Name
Values (Range) Unit Step Default Description
ResetTime 0.000 - 60.000 s 0.001 5.000 Time without slip to reset all signals
Table 103: PSPPPAM Non group settings (basic)
Name
Values (Range) Unit Step Default Description
MeasureMode PosSeq
L1L2
L2L3
L3L1
-
- PosSeq Measuring mode (PosSeq, L1L2, L2L3,
L3L1)
InvertCTcurr No
Yes
- - No Invert current direction
GlobalBaseSel 1 - 12 - 1 1 Selection of one of the Global Base Value
groups
Section 7 1MRK502052-UEN B
Impedance protection
254
Technical manual