ABB REG670 - Function Block

the application manual to get information about how binary inputs are sent from one
IED configuration.
20.13.2 Function block
IEC05000439-2-en.vsd
SMBO
BO1
BO2
BO3
BO4
BO5
BO6
BO7
BO8
BO9
BO10
^BO1
^BO2
^BO3
^BO4
^BO5
^BO6
^BO7
^BO8
^BO9
^BO10
IEC05000439 V2 EN
Figure 510: SMBO function block
20.13.3 Signals
Table 856: SMBO Input signals
Name
Type Default Description
BO1 BOOLEAN 0 Signal name for BO1 in Signal Matrix Tool
BO2 BOOLEAN 0 Signal name for BO2 in Signal Matrix Tool
BO3 BOOLEAN 0 Signal name for BO3 in Signal Matrix Tool
BO4 BOOLEAN 0 Signal name for BO4 in Signal Matrix Tool
BO5 BOOLEAN 0 Signal name for BO5 in Signal Matrix Tool
BO6 BOOLEAN 0 Signal name for BO6 in Signal Matrix Tool
BO7 BOOLEAN 0 Signal name for BO7 in Signal Matrix Tool
BO8 BOOLEAN 0 Signal name for BO8 in Signal Matrix Tool
BO9 BOOLEAN 0 Signal name for BO9 in Signal Matrix Tool
BO10 BOOLEAN 0 Signal name for BO10 in Signal Matrix Tool
20.13.4 Operation principle
The Signal matrix for binary outputs (SMBO) function , see figure 510, receives
logical signal from the IED configuration, which is transferring to the real (hardware)
outputs, via the Signal Matrix Tool (SMT) or ACT. The inputs in SMBO are BO1 to
BO10 and they, as well as the whole function block, can be tag-named. The name tags
will appear in SMT as information which signals shall be connected between physical
IO and the SMBO.
Section 20 1MRK502052-UEN B
Basic IED functions
1126
Technical manual