ABB REG670 - Operation Principle

Name Values (Range) Unit Step Default Description
PulseMode3 Pulsed
Latched
- - Pulsed Setting for pulsed/latched mode for output
3
tPulse3 0.01 - 6000.00 s 0.01 0.10 Pulse time output 3
PulseMode4 Pulsed
Latched
- - Pulsed Setting for pulsed/latched mode for output
4
tPulse4 0.01 - 6000.00 s 0.01 0.10 Pulse time output 4
PulseMode5 Pulsed
Latched
- - Pulsed Setting for pulsed/latched mode for output
5
tPulse5 0.01 - 6000.00 s 0.01 0.10 Pulse time output 5
PulseMode6 Pulsed
Latched
- - Pulsed Setting for pulsed/latched mode for output
6
tPulse6 0.01 - 6000.00 s 0.01 0.10 Pulse time output 6
PulseMode7 Pulsed
Latched
- - Pulsed Setting for pulsed/latched mode for output
7
tPulse7 0.01 - 6000.00 s 0.01 0.10 Pulse time output 7
PulseMode8 Pulsed
Latched
- - Pulsed Setting for pulsed/latched mode for output
8
tPulse8 0.01 - 6000.00 s 0.01 0.10 Pulse time output 8
14.8.6 Operation principle
The PSTO input selects the operator place (LOCAL, REMOTE or ALL). One of the
eight outputs is activated based on the command sent from the operator place selected.
The settings Latchedx and tPulsex (where x is the respective output) will determine if
the signal will be pulsed (and how long the pulse is) or latched (steady). BLOCK will
block the operation of the function – in case a command is sent, no output will be
activated.
PSTO is the universal operator place selector for all control functions.
Although, PSTO can be configured to use LOCAL or ALL operator
places, only REMOTE operator place is used in SPC8GAPC function.
14.9 AutomationBits, command function for DNP3.0
AUTOBITS
14.9.1 Identification
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
AutomationBits, command function for
DNP3
AUTOBITS - -
1MRK502052-UEN B Section 14
Control
771
Technical manual