ABB REG670 - Function Block

15.7.1.1 Function block
ANDQT
INPUT1
INPUT2
INPUT3
INPUT4
OUT
NOUT
IEC09000297-1-en.vsd
IEC09000297 V1 EN
Figure 387: ANDQT function block
15.7.1.2 Signals
Table 546: ANDQT Input signals
Name Type Default Description
INPUT1 BOOLEAN 1 Input signal 1
INPUT2 BOOLEAN 1 Input signal 2
INPUT3 BOOLEAN 1 Input signal 3
INPUT4 BOOLEAN 1 Input signal 4
Table 547: ANDQT Output signals
Name
Type Description
OUT BOOLEAN Output signal
NOUT BOOLEAN Inverted output signal
15.7.1.3 Technical data
Table 548: Number of ANDQT instances
Logic block
Quantity with cycle time
3 ms 8 ms 100 ms
ANDQT - 20 100
15.7.2 Single point indication related signals combining function
block INDCOMBSPQT
The value of single point input (SP_IN) is copied to the value part of the SP_OUT
output. The TIME input is copied to the time part of the SP_OUT output. State input
bits are copied to the corresponding state part of the SP_OUT output. If the state or
value on the SP_OUT output changes, the Event bit in the state part is toggled.
INDCOMBSPQT can propagate the quality, the value and the time stamps of the
signals via IEC 61850.
Section 15 1MRK502052-UEN B
Logic
822
Technical manual